|
|
4 channel HALL controller
The 4 channel HALL controller detects impulses and converts it into position- or
angle informations. It is commonly used with elevators.
With HALL sensors and assembled magnets on the leading rail, the hardware generates
digital signals or RS232 structures, that is transferred to a peripheral device
(e.g. floor indicator or WAV-player). The 4 channel HALL controller generates a
current cabin position and driving direction signal. The device uses normally
2 HALL sensors, but optionally assembled with 4 HALL sensors, the device is able
to generate also a plain-level-signal, that is necessarily used from special periphery
devices. Therefore older elevators can be connected to modern visualisation or
accoustic products. The 4 channel HALL controller recognises automatically the
connected peripheral device. Other/newer devices can easily connected to the
hardware by reprogramming the firmware.
The initial setup of the hardware is done with a teaching cabin movement through all floors. A button stroke activates this setup mode. Two LEDs are indicating the current state of setup and the possible use of a connected peripheral device. 4 additional LEDs, that are electrically assembled parallel to the HALL sensors, shows a change of the magnetic field. As an OEM variant the 4 channel HALL controller can be used as an pulse counter, an angle detector or as a speedometer.
Then feel free to contact us for further information. |
|
|
|
|
|
|
|
|
|
Kippesweg 4 - 97657 Langenleiten - Germany - Tel.: +49(0)9701/907160 |