picture of 8ch servo controller
Modern microcontroller based hardware to position up to 8 servos controlled by a programmable state machine. User can setup start and ending angles as well as delay times for every single servo. With 4 integrated buttons the user is able to interrupt any state in order to have control over the current position. There are also 4 further input pins for connecting reed relay, endswitches etc. in order to control programmed states. Via RS232 and a PC software it is possible to reprogram parameter for a specific servo.
  • Supply voltage: 5-7VDC.
  • Current consumption < 7mA.
  • Output: 8xPWM (50Hz/1-2ms).
  • Input: 4 potential free ports
  • Handling: 4 buttons
  • Interface: RS232
  • Dimensions LxW: 60x50mm
  • Layout: TARGET3001! / Firmware: MPLAB IDE / Software: Borland C++Builder
You need a specific servo application?

Then feel free to contact us for further information.
Softwaredialog / TeachIn
Softwaredialog / Simulation